2.
Which of the following resources would provide the specifications for tightening connection bolts?
3.
What minimum gage of stainless steel should be installed in a gutter?
4.
Where are the requirements for the completion of welding inspections typically found?
5.
When two or more rolled beams or channels are used side-by-side to form a fixture member, they must be connected together at intervals of __________.
6.
Which of the following types of connection can withstand the greatest tensile and shear stresses?
7.
Which of the following indicates equal legs in a steel angle?
8.
Which of the following types of connection can withstand the greatest tensile and shear stresses?
9.
In the floor framing plan, if there is a number in parentheses after the beam callout-e.g., the "18" in "W10 x 49 (18)"-to what does that number refer?
10.
Which of the following grades would be a high-strength anchor bolt?
11.
What sort of PPE (personal protective equipment) is recommended when using cleaning solvent?
12.
What should be done with lifelines, safety harnesses, and shock-absorbing lanyards that have been subjected to impact loading?
13.
What is the longest standard length of a scaffold plank?
14.
On a 120V circuit, what color is the (protective) ground wire?
15.
What is the minimum distance apart that acetylene and oxygen cylinders must be stored?
16.
Which of the following is a correct method for storing acetylene cylinders?
17.
Which of the following is the best choice for hoisting a full gas cylinder?
18.
Cylinders containing ______ shall not be taken into confined spaces.
19.
A dry chemical or carbon dioxide fire extinguisher rated at least ______ must be kept near operations where bottled fuel gases are being used.
20.
No more than ______ of paints, solvents, and chemicals may be stored in a room unless an approved safety storage cabinet is present.